C
HAPTER
19
| RADIUS Client Commands
– 167 –
EXAMPLE
AP(config)# radius-server accounting key green
This setting has not been effective !
If want to take effect, please execute make-radius-effective command !
AP(config)#
radius-server
accounting
timeout-interim
This command sets the interval between transmitting accounting updates
to the RADIUS server.
SYNTAX
radius-server accounting timeout-interim <number_of_seconds>}
number_of_seconds - Number of seconds the access point waits
between transmitting accounting updates. (Range: 60-86400)
DEFAULT SETTING
300
COMMAND MODE
Global Configuration
COMMAND USAGE
The access point sends periodic accounting updates after every interim
period until the user logs off and a “stop” message is sent.
EXAMPLE
AP(config)# radius-server accounting timeout-interim 600
This setting has not been effective !
If want to take effect, please execute make-radius-effective command !
AP(config)#
make-radius-
effective
This command implements the RADIUS settings made in the current CLI
session.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# make-radius-effective
It will take several minutes !
To Next Page
Loading...
Need help?
General
