– 229 –
30 WMM COMMANDS
The access point implements QoS using the Wi-Fi Multimedia (WMM)
standard. Using WMM, the access point is able to prioritize traffic and
optimize performance when multiple applications compete for wireless
network bandwidth at the same time. WMM employs techniques that are a
subset of the IEEE 802.11e QoS standard and it enables the access point to
inter-operate with both WMM-enabled clients and other devices that may
lack any WMM functionality.
wmm This command enables WMM on the access point. Use the no form to
disable WMM.
SYNTAX
wmm required
no wmm
required - WMM must be supported on any device trying to
associated with the access point. Devices that do not support this
feature will not be allowed to associate with the access point.
DEFAULT
Disabled
COMMAND MODE
Interface Configuration (Wireless)
EXAMPLE
AP(if-wireless 0)# wmm required
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
Table 27: WMM Commands
Command Function Mode Page
wmm Enables WMM on the access point IC-W 229
wmm-acknowledge-
policy
Allows the acknowledgement wait time to be enabled
or disabled for each Access Category (AC)
IC-W 230
wmmparam Configures detailed WMM parameters that apply to
the access point (AP) or the wireless clients (BSS)
IC-W 230
To Next Page
Loading...
Need help?
General
