– 120 –
13 SYSTEM MANAGEMENT COMMANDS
These commands are used to configure the password, system logs,
browser management options, clock settings, and a variety of other system
information.
Table 8: System Management Commands
Command Function Mode Page
country Sets the access point country code Exec 121
prompt Customizes the command line prompt GC 122
system name Specifies the host name for the access point GC 122
password Specifies the password for management access GC 123
apmgmtui ssh
enable
Enables the Secure Shell server GC 123
apmgmtui ssh port Sets the Secure Shell port GC 124
ip telnet-server
enable
Enables the Telnet server GC 124
apmgmtip Specifies an IP address or range of addresses
allowed access to management interfaces
GC 128
apmgmtui telnet-
server
Enables Telnet management access GC 124
apmgmtui snmp Enables SNMP management access GC 128
apmgmtui http port Specifies the port to be used by the web browser
interface
GC 125
apmgmtui http
server
Allows the access point to be monitored or
configured from a browser
GC 125
apmgmtui http
session-timeout
Sets the web interface timeout GC 126
apmgmtui https port Specifies the UDP port number used for a secure
HTTP connection to the access point’s Web interface
GC 126
apmgmtui https
server
Enables the secure HTTP server on the access point GC 127
show
apmanagement
Shows the AP management configuration Exec 129
show system Displays system information Exec 129
show version Displays version information for the system Exec 130
show config Displays detailed configuration information for the
system
Exec 130
To Next Page
Loading...
Need help?
General
