– 175 –
22 FILTERING COMMANDS
The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from
wireless clients, and filter traffic using specific Ethernet protocol types.
filter local-bridge This command disables communication between wireless clients. Use the
no form to disable this filtering.
SYNTAX
filter local-bridge <all-VAP | intra-VAP>
no filter local-bridge
all-VAP - When enabled, clients cannot establish wireless
communications with any other client, either those associated to
the same VAP interface or any other VAP interface.
intra-VAP - When enabled, clients associated with a specific VAP
interface cannot establish wireless communications with each other.
Clients can communicate with clients associated to other VAP
interfaces.
DEFAULT
Disabled
COMMAND MODE
Global Configuration
Table 19: Filtering Commands
Command Function Mode Page
filter local-bridge Disables communication between wireless clients GC 175
filter ap-manage Prevents wireless clients from accessing the
management interface
GC 176
filter acl-source-
address
Configures ACL filtering based on source MAC
addresses
GC 176
filter acl-destination-
address
Configures ACL filtering based on destination
MAC addresses
GC 177
filter ethernet-type
enable
Checks the Ethernet type for all incoming and
outgoing Ethernet packets against the protocol
filtering table
GC 177
filter ethernet-type
protocol
Sets a filter for a specific Ethernet type GC 178
show filters Shows the filter configuration Exec 179
To Next Page
Loading...
Need help?
General
