Edge-Core EAP8518 - Show Bridge Br-Conf

C HAPTER 23 | Spanning Tree Commands
– 187 –
==================================
AP#
show bridge br-conf This command displays spanning tree settings for a specified VLAN.
SYNTAX
show bridge br-conf <all | vlan-id>
all - Keyword to show the STP configuration for all VLANs.
vlan-id - Specifies a VLAN ID. (Range: 0-4095)
COMMAND MODE
Exec
EXAMPLE
AP# show bridge br-conf all
BR0 configuration
========================================
BRIDGE MAC : 00:12:cf:a2:54:30
Priority : 32768
Hello Time : 2
Maximum Age : 20
Forward Delay : 0
========================================
AP#
show bridge port-
conf interface
This command displays spanning tree settings for specified interfaces.
SYNTAX
show bridge port-conf interface {all | ethernet | wireless index
<all | vap vap-index>}
all - Keyword to display STP settings for all interfaces.
ethernet - Keyword to display STP settings for the Ethernet
interface.
wireless - Keyword to display STP settings for the Wireless
interface.
vap - Keyword to display STP settings for a specific VAP interface.
COMMAND MODE
Exec
EXAMPLE
AP#show bridge port-conf interface all
ETH0 configuration
========================================