C
HAPTER
6
| Management Settings
Simple Network Management Protocol
– 65 –
SNMP TRAP SETTINGS Traps indicating status changes are issued by the AP to specified trap
managers. You must specify trap managers so that key events are reported
by the AP to your management station (using network management
platforms).
Figure 29: SNMP Trap Settings
The following items are displayed on this page:
◆ Trap Destination — Specifies the recipient of SNMP notifications.
Enter the IP address or the host name. (Host Name: 1 to 63 characters,
case sensitive)
◆ Community — The community string sent with the notification
operation. (Maximum length: 23 characters, case sensitive; Default:
public)
◆ Action — Adds a new SNMP trap destination to the list.
◆ Trap Destination List — Lists the configured SNMP trap destinations.
◆ Trap Configuration — Enables or disables trap status.
â–
sysSystemUp: The access point is up and running.
â–
sysSystemDown: The access point is about to shutdown and
reboot.
◆ Save Trap Config — Applies the new parameters and saves them to
RAM memory. Also prompts a screen to inform you when it has taken
affect. Clicking ‘OK’ returns to the home page. Changes will not be
saved upon a reboot unless the running configuration file is saved.
To Next Page
Loading...
Need help?
General
