Edge-Core EAP8518 - Table 16: RADIUS Client Commands

C HAPTER 19 | RADIUS Client Commands
– 164 –
EXAMPLE
AP(config)# radius-server primary enable
This setting has not been effective !
If want to take effect, please execute make-radius-effective command !
AP(config)#
radius-server
address
This command specifies the primary and secondary RADIUS server
address.
SYNTAX
radius-server {primary | secondary} address <address>
address - IP address of server.
DEFAULT SETTING
10.7.16.96
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# radius-server primary address 192.168.1.9
This setting has not been effective !
If want to take effect, please execute make-radius-effective command !
AP(config)#
radius-server port This command sets the RADIUS server network port.
SYNTAX
radius-server {primary | secondary} port <port_number>
port_number - RADIUS server UDP port used for authentication
messages. (Range: 1024-65535)
DEFAULT SETTING
1812
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# radius-server primary port 1810
This setting has not been effective !