– 191 –
24 WDS BRIDGE COMMANDS
The commands described in this section are used to set the operation
mode for each access point interface and configure Wireless Distribution
System (WDS) forwarding table settings.
wds ap This command enables the bridge operation mode for the radio interface.
SYNTAX
wds ap
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Wireless) VAP
EXAMPLE
AP(if-wireless 0 [VAP 0])#wds ap
AP(if-wireless 0 [VAP 0])#
wds sta This command configures WDS station mode on a VAP interface.
SYNTAX
wds sta ap-ssid <ssid> address <mac-address>
ssid - Severice set identifier. Maximum: 32 characters.
mac-address - The MAC address of the connecting VAP in WDS-AP
mode.
Table 21: WDS Bridge Commands
Command Function Mode Page
wds ap Selects the bridge operation mode for a radio
interface
IC-W
VAP
191
wds sta Configures the MAC addresses of the parent
bridge node
IC-W
VAP
191
show wds wireless Configures MAC addresses of connected child
bridge nodes
Exec 192
To Next Page
Loading...
Need help?
General
