– 139 –
15 SYSTEM CLOCK COMMANDS
These commands are used to configure SNTP and system clock settings on
the access point.
sntp-server ip This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list.
SYNTAX
sntp-server ip <1 | 2> <ip>
1 - First time server.
2 - Second time server.
ip - IP address of an time server (NTP or SNTP).
DEFAULT SETTING
129.6.15.28
132.163.4.101
COMMAND MODE
Global Configuration
COMMAND USAGE
When SNTP client mode is enabled using the sntp-server enabled
command, the sntp-server ip command specifies the time servers from
which the access point polls for time updates. The access point will poll the
time servers in the order specified until a response is received.
Table 12: System Clock Commands
Command Function Mode Page
sntp-server ip Specifies one or more time servers GC 139
sntp-server enabled Accepts time from the specified time servers GC 140
sntp-server date-time Manually sets the system date and time GC 140
sntp-server daylight-saving Sets the start and end dates for daylight
savings time
GC 141
sntp-server timezone Sets the time zone for the access point’s
internal clock
GC 142
show sntp Shows current SNTP configuration settings Exec 142
To Next Page
Loading...
Need help?
General
