– 222 –
28 LINK LAYER DISCOVERY COMMANDS
LLDP allows devices in the local broadcast domain to share information
about themselves. LLDP-capable devices periodically transmit information
in messages called Type Length Value (TLV) fields to neighbor devices.
Advertised information is represented in Type Length Value (TLV) format
according to the IEEE 802.1ab standard, and can include details such as
device identification, capabilities and configuration settings.
This information can be used by SNMP applications to simplify
troubleshooting, enhance network management, and maintain an accurate
network topology.
lldp service This command enables LLDP on the access point. Use the no form to
disable LLDP.
SYNTAX
[no] lldp service
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# lldp service
AP(config)#
Table 25: Link Layer Discovery Commands
Command Function Mode Page
lldp service Enables the transmission of LLDP information GC 222
lldp transmit hold-muliplier Sets the message transmission hold time GC 223
lldp transmit interval Sets the message transmission interval time GC 223
lldp transmit re-init-delay Sets the reinitial delay time GC 224
lldp transmit delay-to-local-
change
Sets the transmission delay value GC 224
show lldp Shows the current LLDP information Exec 225
To Next Page
Loading...
Need help?
General
