– 198 –
26 WIRELESS INTERFACE COMMANDS
The commands described in this section configure connection parameters
for the wireless interfaces.
Table 23: Wireless Interface Commands
Command Function Mode Page
interface wireless Enters wireless interface configuration mode GC 199
vap Provides access to the VAP interface
configuration mode
IC-W 199
a-mpdu Sets the Aggregate MAC Protocol Data Unit (A-
MPDU)
IC-W 199
a-msdu Sets the Aggregate MAC Service Data Unit (A-
MSDU)
IC-W 200
channel Configures the radio channel IC-W 200
transmit-power Adjusts the power of the radio signals
transmitted from the access point
IC-W 202
interface-radio-mode Forces the operating mode of the 802.11g radio IC-W 202
make-rf-setting-
effective
Implements wireless command changes made
in current CLI session
IC-W 203
preamble Sets the length of the 802.11g signal preamble IC-W 203
short-guard-interval Enables the 802.11n short guard interval IC-W 204
beacon-interval Configures the rate at which beacon signals are
transmitted from the access point
IC-W 205
dtim-period Configures the rate at which stations in sleep
mode must wake up to receive broadcast/
multicast transmissions
IC-W 205
rts-threshold Sets the packet size threshold at which an RTS
must be sent to the receiving station prior to
the sending station starting communications
IC-W 206
ssid Configures the service set identifier IC-W-
VAP
207
closed system Opens access to clients without a pre-
configured SSID
IC-W-
VAP
207
assoc- timeout-
interval
Configures the idle time interval (when no
frames are sent) after which a client is
disassociated from the VAP interface
IC-W-
VAP
208
auth- timeout-value Configures the time interval after which clients
must be re-authenticated
IC-W-
VAP
208
shutdown Disables the wireless interface IC-W-
VAP
209
show interface
wireless
Shows the status for the wireless interface Exec 209
show station Shows the wireless clients associated with the
access point
Exec 211
To Next Page
Loading...
Need help?
General
