Edge-Core EAP8518 - Virtual Access Points (VAPs)

C HAPTER 26 | Wireless Interface Commands
– 199 –
interface wireless This command enters wireless interface configuration mode.
SYNTAX
interface wireless <index>
index - The index of the wireless interface. (Range: 0)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# interface wireless 0
Enter Wireless configuration commands, one per line.
AP(if-wireless 0)#
vap This command provides access to the VAP (Virtual Access Point) interface
configuration mode.
SYNTAX
vap <vap-index>
vap-index - The number that identifies the VAP interface.
(Options: 0-7)
DEFAULT SETTING
None
COMMAND MODE
Interface Configuration (Wireless)
EXAMPLE
AP(if-wireless 0)#vap 0
AP(if-wireless 0: VAP[0])#
a-mpdu This command enables and sets the Aggregate MAC Protocol Data Unit
(A-MPDU).
SYNTAX
a-mpdu {enable | disable | length | <length >}
enable - Enable A-MPDU.
disable - Disable A-MPDU.
length - 1024-65535 bytes.