C
HAPTER
26
| Wireless Interface Commands
ā 200 ā
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Wireless)
EXAMPLE
AP(if-wireless 0)#a-mpdu enable
AP(if-wireless 0)#
a-msdu This command enables and sets the Aggregate MAC Service Data Unit
(A-MSDU).
SYNTAX
a-msdu {enable | disable | length <length>}
enable - Enable A-MSDU.
disable - Disable A-MSDU.
length - 1024-65535 bytes.
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Wireless)
EXAMPLE
AP(if-wireless 0)#a-msdu enable
AP(if-wireless 0)#
channel This command configures the radio channel through which the access point
communicates with wireless clients.
SYNTAX
channel {ht20 <ht20-channel> | ht40 <ht40-channel> | auto}
ht20-channel - The 802.11n 20 MHz channel number:
11ng mode: 01, 02, 03, 04, 05, 06, 07, 08, 09, 10, 11
11na mode: 36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112,
116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165
To Next Page
Loading...
