C
HAPTER
8
| Wireless Settings
Interface Mode
– 83 –
INTERFACE MODE
The access point can operate in two modes, IEEE 802.11a/n only, or
802.11g/n only. Also note that 802.11g is backward compatible with
802.11b, operating in the 2.4 GHz band. The 802.11a/n mode operates in
the 5 GHz band.
N
OTE
:
The EAP8518 radio can operate in 2.4 GHz mode or 5 GHz mode. It
does not operate at 2.4 GHz and 5 GHz modes at the same time. You must
first select the basic radio operating mode you want to use for your
network.
Figure 42: Interface Mode
The following items are displayed on the Interface Mode Selection page:
◆ Interface0 Mode — Selects the mode of the radio interface:
■
11ng: All 802.11g and n clients can communicate with the wireless
AP/ Router (up to 300 Mbps) using the 2.4 GHz band, but data
transmission rates may be slowed to compensate for 802.11g
clients.
■
11na: All 802.11a and n clients can communicate with the wireless
AP/ Router (up to 300 Mbps) using the 5 GHz band, but data
transmission rates may be slowed to compensate for 802.11a
clients.
To Next Page
Loading...
