Edge-Core EAP8518

C HAPTER 12 | General Commands
– 119 –
reset This command restarts the system or restores the factory default settings.
SYNTAX
reset <board | configuration>
board - Reboots the system.
configuration - Resets the configuration settings to the factory
defaults, and then reboots the system.
DEFAULT SETTING
None
COMMAND MODE
Exec
COMMAND USAGE
When the system is restarted, it will always run the Power-On Self-Test.
EXAMPLE
This example shows how to reset the system:
AP#reset board
Please wait a moment...
show line This command displays the console port’s configuration settings.
COMMAND MODE
Exec
EXAMPLE
The console port settings are fixed at the values shown below.
AP#show line
Console Line Information
======================================================
databits : 8
parity : none
speed : 115200
stop bits : 1
======================================================
AP#