C
HAPTER
9
| Maintenance Settings
Upgrading Firmware
– 99 –
Figure 51: Firmware
The following items are displayed on this page:
◆ Firmware Version — Displays what version of software is being used
as a runtime image - “Active”, and what version is a backup image -
“Backup”. You may specify up to two images.
◆ Next Boot Image — Specifies what version of firmware will be used as
a runtime image upon bootup.
◆ Set Next Boot — Applies the runtime image setting.
◆ Local — Downloads an operation code image file from the web
management station to the access point using HTTP. Use the Browse
button to locate the image file locally on the management station and
click Start Upgrade to proceed.
■
New Firmware File: Specifies the name of the code file on the
server. The new firmware file name should not contain slashes (\ or
/), the leading letter of the file name should not be a period (.), and
the maximum length for file names is 32 characters for files on the
access point. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
To Next Page
Loading...
Need help?
General
