C
HAPTER
6
| Management Settings
Simple Network Management Protocol
– 69 –
Figure 32: SNMPv3 Targets
The following items are displayed on this page:
◆ Target ID — A user-defined name that identifies a receiver of
notifications. (Maximum length: 32 characters)
◆ IP Address — Specifies the IP address of the receiving management
station.
◆ UDP Port — The UDP port that is used on the receiving management
station for notification messages.
◆ SNMP User — The defined SNMP v3 user that is to receive notification
messages.
◆ Notification Filter — The name of a user-defined notification filter
that is applied to the target.
SNMPV3
NOTIFICATION FILTERS
SNMP v3 users can be configured to receive notification messages from the
access point. An SNMP Target ID is created that specifies the SNMP v3 user,
IP address, and UDP port. A user-defined notification filter can be created
so that specific notifications can be prevented from being sent to particular
targets.
Figure 33: SNMP Notification Filter
To Next Page
Loading...
Need help?
General
