C
HAPTER
5
| System Settings
System Time
– 55 –
SNTP SERVER
SETTINGS
Configures the access point to operate as an SNTP client. When enabled, at
least one time server IP address must be specified.
◆ SNTP Status — Enables/disables SNTP. (Default: enabled)
◆ Primary Server — The IP address of an SNTP or NTP time server that
the access point attempts to poll for a time update.
◆ Secondary Server — The IP address of a secondary SNTP or NTP time
server. The access point first attempts to update the time from the
primary server; if this fails it attempts an update from the secondary
server.
TIME ZONE SETTING SNTP uses Greenwich Mean Time, or GMT (sometimes referred to as
Coordinated Universal Time, or UTC) based on the time at the Earth’s
prime meridian, zero degrees longitude. To display a time corresponding to
your local time, you must indicate the number of hours your time zone is
located before (east) or after (west) GMT.
◆ Time Zone — Select from the scroll down list the locale you are
situated most close to, for example for New York, select ‘(GMT-05)
Eastern Time (US & Canada)’.
DAYLIGHT SAVING
SETTINGS
The access point provides a way to automatically adjust the system clock
for Daylight Savings Time changes. To use this feature you must define the
month and date to begin and to end the change from standard time.
During this period the system clock is set back by one hour.
◆ Daylight Saving Status — Enalbes/disables daylight savings time.
(Default: disabled)
When enabled, set the month, day, and week to start and stop the
daylight savings time.
To Next Page
Loading...
Need help?
General
