Edge-Core EAP8518 User Manual

– 180 –
23 SPANNING TREE COMMANDS
The commands described in this section are used to set the MAC address
table aging time and spanning tree parameters for both the Ethernet and
wireless interfaces.
Table 20: Spanning Tree Commands
Command Function Mode Page
bridge stp service Enables the Spanning Tree feature GC 181
bridge stp br-conf
forwarding-delay
Configures the spanning tree bridge forward
time
GC 181
bridge stp br-conf hello-
time
Configures the spanning tree bridge hello time GC 182
bridge stp br-conf max-age Configures the spanning tree bridge maximum
age
GC 182
bridge stp br-conf priority Configures the spanning tree bridge priority GC 183
bridge stp port-conf
interface
Enters STP interface configuration mode GC 183
bridge-link path-cost Configures the spanning tree path cost for the
Ethernet port
IC-E 184
bridge-link port-priority Configures the spanning tree priority for the
Ethernet port
IC-E 184
vap Selects the VAP interface in STP interface
configuration mode
GC-
STP
185
path-cost Sets the path cost for a VAP interface in STP
interface configuration mode
GC-
STP
185
port-priority Sets the port priority for a VAP interface in STP
interface configuration mode
GC-
STP
186
show bridge stp Displays the global spanning tree settings Exec 186
show bridge br-conf Displays spanning tree settings for specified
VLANs
Exec 187
show bridge port-conf Displays spanning tree settings for specified
interfaces
Exec 187
show bridge status Displays STP bridge status for a specified VLAN
or all VLANs
Exec 188
show bridge forward
address
Displays STP settings for forwarding MAC
addesses on specified interfaces or VLANs
Exec 189

Edge-Core EAP8518 Specifications

General

Brand	Edge-Core
Model	EAP8518
Category	Wireless Access Point
Language	English