Edge-Core EAP8518 - Show Snmp Target; Show Snmp Users

C HAPTER 17 | SNMP Commands
– 156 –
show snmp users This command displays the SNMP v3 users and settings.
SYNTAX
show snmp users
COMMAND MODE
Exec
EXAMPLE
AP# show snmp users
User List:
==================================
UserName : chris
GroupName : testgroup
AuthType : None
PrivType : None
UserName : david
GroupName : group2
AuthType : MD5, Passphrase: ****************
PrivType : DES, Passphrase: ****************
==================================
AP#
show snmp target This command displays the SNMP v3 notification target settings.
SYNTAX
show snmp target
COMMAND MODE
Exec
EXAMPLE
AP# show snmp target
Target List:
==================================
Target ID : christraps
IP Address : 192.168.1.33
User Name : chris
UDP Port : 4321
Filter ID : Not Defined
==================================
AP#