Edge-Core EAP8518 - Figure 18: Quick Start - Step 3; Step

C HAPTER 4 | Initial Configuration
Quick Start
– 46 –
STEP 3 The Step 3 page of the Quick Start configures radio interface settings.
Figure 18: Quick Start - Step 3
The following items are displayed on this page:
INTERFACE SETTING
◆ WiFi Mode — Sets the mode of operation of the radio chip to
802.11n/g (2.4 GHz) or 802.11n/a (5 GHz). (Default: 11n/g)
BASIC SETTING
◆ SSID — Sets the service set identifier for the primary VAP.
(Default: EC_VAP_0)
SECURITY
◆ Association Mode — Selects the security mode for association of
other access points and wireless devices to the access point. For more
information, see “Wireless Security Settings” on page 90.
(Default: Open System; Range: Open System, WPA, WPA-PSK, WPA2,
WPA2-PSK, WPA-WPA2-mixed, or WPA-WPA2-PSK-mixed)
◆ Encryption Mode — The available data encryption methods depend on
the selected Association Mode. (Default: None)
■
None: Implements no encryption for Open System association.
■
WEP: WEP is used as the multicast encryption cipher. You should
select WEP only when both WPA and WEP clients are supported.