Edge-Core EAP8518 - Spanning Tree Commands

C HAPTER 23 | Spanning Tree Commands
– 188 –
Link Port Priority : 32
Link Path Cost : 4
========================================
ATH0 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH1 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH2 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH3 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH4 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH5 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH6 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
ATH7 configuration
========================================
Link Port Priority : 32
Link Path Cost : 19
========================================
AP#
show bridge status This command displays STP bridge status for a specified VLAN or all VLANs.
SYNTAX
show bridge status <all | vlan-id>
all - Keyword to show the bridge status for all VLANs.