Edge-Core EAP8518 - RADIUS Client CLI Commands; RADIUS Server Configuration

– 163 –
19 RADIUS CLIENT COMMANDS
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access for RADIUS-aware devices to the network. An authentication
server contains a database of credentials, such as users names and
passwords, for each wireless client that requires access to the access point.
radius-server enable This command enables the RADIUS server.
SYNTAX
radius-server {primary | secondary} enable
primary - Specifies the primary RADIUS server.
secondary - Specifies the secondary RADIUS server.
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
Table 16: RADIUS Client Commands
Command Function Mode Page
radius-server enable Enables the RADIUS server. GC 163
radius-server address Specifies the RADIUS server GC 164
radius-server port Sets the RADIUS server network port GC 164
radius-server key Sets the RADIUS encryption key GC 165
radius-server accounting
address
Sets the RADIUS server accounting address GC 165
radius-server accounting
port
Sets the RADIUS server accounting port GC 166
radius-server accounting
key
Sets the RADIUS server accounting key GC 166
radius-server accounting
timeout-interim
Sets the interval between transmitting
accounting updates to the RADIUS server
GC 167
make-radius-effective Implements RADIUS command changes made
in current CLI session.
GC 167
show radius Shows the current RADIUS settings Exec 168