C
HAPTER
23
| Spanning Tree Commands
– 181 –
bridge stp service This command enables the Spanning Tree Protocol. Use the no form to
disable the Spanning Tree Protocol.
SYNTAX
[no] bridge stp service
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
EXAMPLE
This example globally enables the Spanning Tree Protocol.
AP(config)bridge stp service
AP(config)
bridge stp br-conf
forwarding-delay
Use this command to configure the spanning tree bridge forward time
globally for the wireless bridge.
SYNTAX
bridge stp br-conf forwarding-delay <seconds>
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
DEFAULT SETTING
15 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the maximum time (in seconds) the root device will
wait before changing states (i.e., discarding to learning to forwarding). This
delay is required because every device must receive information about
topology changes before it starts to forward frames. In addition, each port
needs time to listen for conflicting information that would make it return to
the discarding state; otherwise, temporary data loops might result.
EXAMPLE
AP(config)#bridge stp br-conf forwarding-delay 20
AP(config)#
To Next Page
Loading...
Need help?
General
