C
HAPTER
29
| VLAN Commands
– 228 –
vlan-id This command configures the default VLAN ID for the VAP interface.
SYNTAX
vlan-id <vlan-id>
vlan-id - Default VLAN ID. (Range: 1-4094)
DEFAULT SETTING
1
COMMAND MODE
Interface Configuration (Wireless-VAP)
COMMAND USAGE
◆ To implement the default VLAN ID setting for VAP interface, the access
point must enable VLAN support using the vlan command.
◆ When VLANs are enabled, the access point tags frames received from
wireless clients with the default VLAN ID for the VAP interface.
EXAMPLE
AP(if-wireless 0: VAP[0])# vlan-ID 6
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
To Next Page
Loading...
