C
HAPTER
17
| SNMP Commands
– 150 –
snmp-server trap This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
SYNTAX
snmp-server trap <trap>
no snmp-server trap <trap>
trap - One of the following SNMP trap messages:
dot11InterfaceAGFail - The 802.11a or 802.11g interface has
failed.
dot11InterfaceBFail - The 802.11b interface has failed.
dot11StationAssociation - A client station has successfully
associated with the access point.
dot11StationAuthentication - A client station has been
successfully authenticated.
dot11StationReAssociation - A client station has successfully
re-associated with the access point.
dot11StationRequestFail - A client station has failed
association, re-association, or authentication.
dot1xAuthFail - A 802.1X client station has failed RADIUS
authentication.
dot1xAuthNotInitiated - A client station did not initiate
802.1X authentication.
dot1xAuthSuccess - A 802.1X client station has been
successfully authenticated by the RADIUS server.
dot1xMacAddrAuthFail - A client station has failed MAC
address authentication with the RADIUS server.
dot1xMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address with the RADIUS server.
iappContextDataSent - A client station’s Context Data has
been sent to another access point with which the station has
associated.
iappStationRoamedFrom - A client station has roamed from
another access point (identified by its IP address).
iappStationRoamedTo - A client station has roamed to
another access point (identified by its IP address).
localMacAddrAuthFail - A client station has failed
authentication with the local MAC address database on the
access point.
localMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address with the local database on the
access point.
pppLogonFail - The access point has failed to log onto the
PPPoE server using the configured user name and password.
To Next Page
Loading...
