C
HAPTER
18
| Flash/File Commands
– 161 –
EXAMPLE
AP# dual-image boot-image A
Change image to A
AP#
copy This command copies a boot file, code image, or configuration file between
the access point’s flash memory and a FTP/TFTP server. When you save the
configuration settings to a file on a FTP/TFTP server, that file can later be
downloaded to the access point to restore system operation. The success
of the file transfer depends on the accessibility of the FTP/TFTP server and
the quality of the network connection.
SYNTAX
copy {ftp [firmware | config] <file-name> <ip-address> <user-
name> <password> | tftp [firmware | config] <file-name> <ip-
address>}
copy config {ftp <file-name> <ip-address> <user-name>
<password> | tftp <file-name> <ip-address>}
copy running startup
ftp - Keyword that allows you to copy to/from an FTP server.
tftp - Keyword that allows you to copy to/from a TFTP server.
firmware - Keyword that allows you to copy a software image file
from an FTP/TFTP server to flash memory.
config - Keyword that allows you to copy a configuration file to/
from an FTP/TFTP server.
running startup - Keywords that save the current running
configuration to the startup configuration file in flash memory.
file-name - The name of a file to copy.
ip-address - The IP address of an FTP or TFTP server.
user-name - The access user name for the FTP server.
password - The access password for the FTP server.
DEFAULT SETTING
None
COMMAND MODE
Exec
COMMAND USAGE
◆ Only a configuration file can be uploaded to an FTP/TFTP server, but
every type of file can be downloaded to the access point.
◆
The destination file name should not contain slashes (\ or /),
the leading
letter of the file name should not be a period (.), and the maximum
length for file names on the FTP/TFTP server is 255 characters or 32
To Next Page
Loading...
