C
HAPTER
23
| Spanning Tree Commands
– 184 –
EXAMPLE
AP(config)# bridge stp port-conf interface wireless 0
Enter Wireless configuration commands, one per line.
AP(stp-if-wireless 0)#
bridge-link path-
cost
Use this command to configure the spanning tree path cost for the
Ethernet port.
SYNTAX
bridge-link path-cost <cost>
cost - The path cost for the port. (Range: 1-65535)
DEFAULT SETTING
4
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
◆ This command is used by the Spanning Tree Protocol to determine the
best path between devices. Therefore, lower values should be assigned
to ports attached to faster media, and higher values assigned to ports
with slower media.
◆ Path cost takes precedence over port priority.
EXAMPLE
AP(if-wireless a)#bridge-link path-cost 1 50
AP(if-wireless a)#
bridge-link port-
priority
Use this command to configure the priority for the Ethernet port.
SYNTAX
bridge-link port-priority <priority>
priority - The priority for a port. (Range: 1-255)
DEFAULT SETTING
32
COMMAND MODE
Interface Configuration (Ethernet)
To Next Page
Loading...
