Chapter 4
| System Management Commands
Banner Information
– 100 –
banner configure
department
This command is used to configure the department information displayed in the
banner. Use the no form to restore the default setting.
Syntax
banner configure department dept-name
no banner configure department
dept-name - The name of the department.
(Maximum length: 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Input strings cannot contain spaces. The banner configure department
command interprets spaces as data input boundaries. The use of underscores ( _ )
or other unobtrusive non-letter characters is suggested for situations where white
space is necessary for clarity.
Example
Console(config)#banner configure department R&D
Console(config)#
banner configure
equipment-info
This command is used to configure the equipment information displayed in the
banner. Use the no form to restore the default setting.
Syntax
banner configure equipment-info manufacturer-id mfr-id floor floor-id
row row-id rack rack-id shelf-rack sr-id manufacturer mfr-name
no banner configure equipment-info [floor | manufacturer | manufacturer-
id | rack | row | shelf-rack]
mfr-id - The name of the device model number.
floor-id - The floor number.
row-id - The row number.
rack-id - The rack number.
sr-id - The shelf number in the rack.
mfr-name - The name of the device manufacturer.
Maximum length of each parameter: 32 characters
To Next Page
Loading...
