Chapter 4
| System Management Commands
Switch Clustering
– 175 –
Command Mode
Global Configuration
Command Usage
â—† The maximum number of cluster Members is 16.
â—† The maximum number of cluster Candidates is 100.
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-16)
Command Mode
Privileged Exec
Command Usage
â—† This command only operates through a Telnet connection to the Commander
switch. Managing cluster Members using the local console CLI on the
Commander is not supported.
â—† There is no need to enter the username and password for access to the Member
switch CLI.
Example
Console#rcommand id 1
CLI session with the ECS4120-28T is opened.
To end the CLI session, enter [Exit].
Vty-0#
show cluster This command shows the switch clustering configuration.
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General