Edge-Core ECS4120 Series

Chapter 25 | LLDP Commands
– 751 –
◆ This attribute must comply with the following rule:
(4 * tx-delay) ≤
refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the no form to disable this feature.
Syntax
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp basic-tlv
management-ip-
address
This command configures an LLDP-enabled port to advertise the management
address for this device. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv management-ip-address
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)