Chapter 3
| General Commands
– 90 –
◆ The “#” character is appended to the end of the prompt to indicate that the
system is in privileged access mode.
Example
Console>enable
Password: [privileged level password]
Console#
Related Commands
disable (92)
enable password (218)
quit This command exits the configuration program.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
The quit and exit commands can both exit the configuration program.
Example
This example shows how to quit a CLI session:
Console#quit
% CLI exit session
***************************************************************
WARNING - MONITORED ACTIONS AND ACCESSES
Station's information:
Floor / Row / Rack / Sub-Rack
/ / /
DC power supply:
Power Source A: Floor / Row / Rack / Electrical circuit
/ / /
Number of LP:
Position MUX:
IP LAN:
Note:
***************************************************************
Username:
To Next Page
Loading...
Need help?
General