Chapter 4
| System Management Commands
Line
– 141 –
Example
To specify 2 stop bits, enter this command:
Console(config-line-console)#stopbits 2
Console(config-line-console)#
timeout login
response
This command sets the interval that the system waits for a user to log into the CLI.
Use the no form to restore the default setting.
Syntax
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 10 - 300 seconds)
Default Setting
300 seconds
Command Mode
Line Configuration
Command Usage
â—† If a login attempt is not detected within the timeout interval, the connection is
terminated for the session.
â—† This command applies to both the local console and Telnet connections.
â—† The timeout for Telnet cannot be disabled.
â—† Using the command without specifying a timeout restores the default setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line-console)#timeout login response 120
Console(config-line-console)#
To Next Page
Loading...
Need help?
General