Chapter 21
| VLAN Commands
GVRP and Bridge Extension Commands
– 561 –
show gvrp
configuration
This command shows if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
GVRP Configuration : Disabled
Console#
To Next Page
Loading...
