Chapter 25
| LLDP Commands
– 750 –
lldp reinit-delay This command configures the delay before attempting to re-initialize after LLDP
ports are disabled or the link goes down. Use the no form to restore the default
setting.
Syntax
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems LLDP
MIB associated with this port is deleted.
Example
Console(config)#lldp reinit-delay 10
Console(config)#
lldp tx-delay This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the no form
to restore the default setting.
Syntax
lldp
tx-delay seconds
no lldp
tx-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
â—† The transmit delay is used to prevent a series of successive LLDP transmissions
during a short period of rapid changes in local LLDP MIB objects, and to
increase the probability that multiple, rather than single changes, are reported
in each transmission.
To Next Page
Loading...
Need help?
General