Chapter 25
| LLDP Commands
– 757 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#
lldp dot3-tlv mac-phy This command configures an LLDP-enabled port to advertise its MAC and physical
layer capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises MAC/PHY configuration/status which includes information
about auto-negotiation support/capabilities, and operational Multistation Access
Unit (MAU) type.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv
max-frame
This command configures an LLDP-enabled port to advertise its maximum frame
size. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Refer to “Frame Size” on page 118 for information on configuring the maximum
frame size for this switch.
To Next Page
Loading...
Need help?
General