Edge-Core ECS4120 Series

Chapter 26 | CFM Commands
Fault Generator Operations
– 811 –
Default Setting
10 seconds
Command Mode
CFM Domain Configuration
Example
This example sets the reset time after which another fault alarm can be generated.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify reset-time 7
Console(config-ether-cfm)#
show ethernet cfm
fault-notify-generator
This command displays configuration settings for the fault notification generator.
Syntax
show ethernet cfm fault-notify-generator mep mpid
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the fault notification settings configured for one MEP.
Console#show ethernet cfm fault-notify-generator mep 1
MD Name MA Name Highest Defect Lowest Alarm Alarm Time Reset Time
------------ ------------ -------------- ------------- ---------- ----------
voip rd none macRemErrXcon 3sec. 10sec.
Console#
Table 165: show fault-notify-generator - display description
Field Description
MD Name The maintenance domain for this entry.
MA Name The maintenance association for this entry.
Hihest Defect The highest defect that will generate a fault alarm. (This is disabled by
default.)
Lowest Alarm The lowest defect that will generate a fault alarm (see the mep fault-notify
lowest-priority command).