Edge-Core ECS4120 Series

Chapter 15 | Congestion Control Commands
Automatic Traffic Control Commands
– 471 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
Related Commands
auto-traffic-control alarm-fire-threshold (467)
auto-traffic-control apply-timer (463)
snmp-server
enable port-traps atc
broadcast-control-
release
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and the release timer
expires. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-control-release
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-
release
Console(config-if)#
Related Commands
auto-traffic-control alarm-clear-threshold (466)
auto-traffic-control action (465)
auto-traffic-control release-timer (464)
snmp-server
enable port-traps atc
multicast-alarm-clear
This command sends a trap when multicast traffic falls beneath the lower threshold
after a storm control response has been triggered. Use the no form to disable this
trap.
Syntax
[no] snmp-server enable port-traps atc multicast-alarm-clear
Default Setting
Disabled