Edge-Core ECS4120 Series

Chapter 23 | Quality of Service Commands
– 625 –
This example creates a class map call “rd-class#3,” and sets it to match packets
marked for VLAN 1.
Console(config)#class-map rd-class#3 match-any
Console(config-cmap)#match vlan 1
Console(config-cmap)#
rename This command redefines the name of a class map or policy map.
Syntax
rename map-name
map-name - Name of the class map or policy map. (Range: 1-32 characters)
Command Mode
Class Map Configuration
Policy Map Configuration
Example
Console(config)#class-map rd-class#1
Console(config-cmap)#rename rd-class#9
Console(config-cmap)#
policy-map This command creates a policy map that can be attached to multiple interfaces,
and enters Policy Map configuration mode. Use the no form to delete a policy map.
Syntax
[no] policy-map policy-map-name
policy-map-name - Name of the policy map. (Range: 1-32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ Use the policy-map command to specify the name of the policy map, and then
use the class command to configure policies for traffic that matches the criteria
defined in a class map.
◆ A policy map can contain multiple class statements that can be applied to the
same interface with the service-policy command.