Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 737 –
Example
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR6 Profile Name Start IPv6 Addr. End IPv6 Addr.
--------------------- ------------------------- -------------------------
rd ff01::fe ff01::ff
Console#
show mvr6 interface This command shows MVR6 configuration settings for interfaces attached to the
MVR6 VLAN.
Syntax
show mvr6 [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all attached interfaces.
Command Mode
Privileged Exec
Example
The following displays information about the interfaces attached to the MVR6
VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Leave Static Group Address
-------- -------- ------------------- ---------------- ---------------------
Eth1/ 1 Source Active/Up
Eth1/ 2 Receiver Active/Forwarding Disabled ff00::1(VLAN1)
Console#
Table 149: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR6.
Type Shows the MVR6 port type.
Status Shows the MVR6 status and interface status. MVR6 status for source ports is
“ACTIVE” if MVR 6is globally enabled on the switch. MVR6 status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR6 groups, or a multicast group has been statically assigned to
an interface.
To Next Page
Loading...
Need help?
General