Edge-Core ECS4120 Series

Chapter 9 | General Security Measures
Network Access (MAC Address Authentication)
– 298 –
Example
Console#show network-access interface ethernet 1/1
Global secure port information
Reauthentication Time : 1800
MAC Address Aging : Enabled
Port : 1/1
MAC Authentication : Disabled
MAC Authentication Intrusion Action : Block traffic
MAC Authentication Maximum MAC Counts : 1024
Maximum MAC Counts : 1024
Dynamic VLAN Assignment : Enabled
Dynamic QoS Assignment : Disabled
MAC Filter ID : Disabled
Guest VLAN : Disabled
Link Detection : Disabled
Detection Mode : Link-down
Detection Action : Trap
Console#
show network-access
mac-address-table
Use this command to display secure MAC address table entries.
Syntax
show network-access mac-address-table [static | dynamic]
[address mac-address [mask]] [interface interface] [sort {address |
interface}]
static - Specifies static address entries.
dynamic - Specifies dynamic address entries.
mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)
mask - Specifies a MAC address bit mask for filtering displayed addresses.
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
sort - Sorts displayed entries by either MAC address or interface.
Default Setting
Displays all filters.
Command Mode
Privileged Exec
Command Usage
When using a bit mask to filter displayed MAC addresses, a 1 means “care” and a 0
means “don't care”. For example, a MAC of 00-00-01-02-03-04 and mask FF-FF-FF-