Chapter 11
| Interface Commands
Power Savings
– 421 –
Example
Console#show cable-diagnostics interface ethernet 1/24
Port Type Link Pair A Pair B Pair C Pair D Last
Status meters meters meters meters Updated
-------- ---- -------- -------- -------- -------- -------- -------------------
Eth 1/24 GE Down NC (0) NC (0) NC (0) NC (0) 2000-12-31 08:28:59
Console#
show loop internal This command shows the results of a loop back test.
Syntax
show loop internal interface [interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Example
Console#show loop internal interface ethernet 1/1
Port Test Result Last Update
-------- -------------- --------------------
Eth 1/1 Succeeded 2015-05-15 09:15:02
Console#
Power Savings
power-save This command enables power savings mode on the specified port. Use the no form
to disable this feature.
Syntax
[no] power-save
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
To Next Page
Loading...
Need help?
General