Chapter 2
| Using the Command Line Interface
CLI Command Groups
– 84 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service
provider networks
523
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service
provider networks
1257
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures protocol VLANs,
voice VLANs, and QinQ tunneling
555
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for TCP/UDP traffic types, IP precedence, and
DSCP
601
Quality of Service Configures Differentiated Services 621
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
639
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
745
Connectivity Fault
Management
Configures connectivity monitoring using continuity check
messages, fault verification through loopback messages, and
fault isolation by examining end-to-end connections
between Provider Edge devices or between Customer Edge
devices
773
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and maintain
the links to subscriber CPEs
815
Domain Name Service Configures DNS services. 827
Dynamic Host
Configuration Protocol
Configures DHCP client and relay functions 837
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
849
IP Routing Configures static routing 897
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
* ECS4120-28P
Table 6: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General