ELTEX ESR-3100 - Page 253

ESR series service routers.ESR-Series. User manual
253
Step Description Command Keys
esr(config-ospf)# redistribute bgp
<AS> [ route-map <NAME> ]
<AS> – stand alone system
number, takes values of
[1..4294967295].
<NAME> – name of the route
map that will be used for
advertised BGP routes filtration
and modification, set by the
string of up to 31 characters.
esr(config-ipv6-ospf)# redistribute
bgp <AS> [ route-map <NAME> ]
13 Enable OSFP process. esr(config-ospf)# enable
esr(config-ipv6-ospf)# enable
14 Create OSFP area and switch to the
scope configuration mode.
esr(config-ospf)# area <AREA_ID> <AREA_ID> – area identifier,
defined as AAA.BBB.CCC.DDD
where each part takes values
of [0..255].
esr(config-ipv6-ospf)# area
<AREA_ID>
15 Enable subnets advertising (optional). esr(config-ospf-area)# network
<ADDR/LEN>
<ADDR/LEN> – subnet
address, set in the following
format:
AAA.BBB.CCC.DDD/NN –
network IP address with prefix
mask, where AAA-DDD take
values of [0..255] and EE takes
values of [1..32].
esr(config-ipv6-ospf-area)#
network <IPV6-ADDR/LEN>
<IPV6-ADDR/LEN> – IPv6
address and mask of a subnet,
defined as X:X:X:X::X/EE where
each X part takes values in
hexadecimal format [0..FFFF]
and EE takes values of [1..128].