ELTEX ESR-3100 - Page 306

ESR series service routers.ESR-Series. User manual
306
•
•
•
•
•
•
•
•
•
•
•
•
•
Step Description Command Keys
esr(config-isis)#redistribute
ospf <ID> <ROUTE-TYPE>
[ route-map <NAME> ] [is-type
<LEVEL>]
<ID> – process number, takes values of
[1..65535].
<ROUTE-TYPE> – route type:
intra-area – OSPF process routes
advertising within a zone;
inter-area – OSPF process routes
advertising between zones;
external1 – OSPF format 1 external
routes advertising;
external2 – OSPF format 2 external
routes advertising;
<NAME> – name of the route map that will
be used for advertised OSFP routes
filtration and modification, set by the string
of up to 31 characters;
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
esr(config-isis)#redistribute
ipv6 ospf <ID> <ROUTE-
TYPE> [ route-map <NAME> ]
[is-type <LEVEL>]
esr(config-isis)# redistribute
isis <ID> <ROUTE-TYPE>
[ route-map <NAME> ] [is-type
<LEVEL>]
<ID> – process number, takes values of
[1..65535].
<ROUTE-TYPE> – route type:
level-1 – level 1 routes advertising;
level-2 – level 2 routes advertising;
inter-area – IS-IS process routes
advertising between zones;
<NAME> – name of the route map that will
be used for advertised IS-IS routes filtration
and modification, set by the string of up to
31 characters;
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
esr(config-isis)#redistribute
rip [ route-map <NAME> ] [is-
type <LEVEL>]
<NAME> – name of the route map that will
be used for advertised RIP routes filtration
and modification, set by the string of up to
31 characters;
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.