ELTEX ESR-3100 - Page 308

ESR series service routers.ESR-Series. User manual
308
•
•
•
•
•
•
•
•
•
•
•
•
•
Step Description Command Keys
25 Set the metric value for the
interface (optional).
esr(config-if-gi)# isis metric
<VALUE> [<LEVEL>]
<VALUE>– number, may take values
[1..16777215];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level
2.
26 Set defines which routing
layer on the interface the
current IS-IS process will run
on (optional).
esr(config-if-gi)# isis circuit-
type {<LEVEL>}
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-1-2 – operate on levels 2 and 2;
level-2-only – operate only on level
2.
27 Set the interval for sending
hello packets (optional).
esr(config-if-gi)# isis hello-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level
2.
28 Set the multiplier for
calculating and sending Hold
Time (optional).
esr(config-if-gi)# isis hello-
multiplier <VALUE> [<LEVEL>]
<VALUE>– number, may take values
[3..1000];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level
2.
29 Set the interface to point-to-
point IS-IS protocol mode
(optional).
esr(config-if-gi)# isis network
point-to-point
30 Set the interval for generating
and sending CSNP (optional).
esr(config-if-gi)# isis csnp-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level
2.
31 Set the interval for generating
and sending PSNP (optional).
esr(config-if-gi)# isis psnp-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level
2.