ELTEX ESR-3100 - Page 371

To Next Page

To Previous Page

ESR series service routers.ESR-Series. User manual

371

Create eBGP session with CE_SiteA and allow routes transmission to the BGP peer:

ESR1

ESR1(config)# router bgp 65500

ESR1(config-bgp)# vrf Customer1

ESR1(config-bgp-vrf)# router-id 192.168.32.1

ESR1(config-bgp-vrf)# neighbor 192.168.32.2

ESR1(config-bgp-vrf-neighbor)# remote-as 65505

ESR1(config-bgp-vrf-neighbor)# update-source 192.168.32.1

ESR1(config-bgp-vrf-neighbor)# address-family ipv4 unicast

ESR1(config-bgp-neighbor-af-vrf)# route-map OUTPUT out

ESR1(config-bgp-neighbor-af-vrf)# enable

ESR1(config-bgp-neighbor-af-vrf)# exit

ESR1(config-bgp-vrf-neighbor)# enable

ESR1(config-bgp-vrf-neighbor)# exit

ESR1(config-bgp-vrf)# address-family ipv4 unicast

ESR1(config-bgp-vrf-af)# redistribute connected

ESR1(config-bgp-vrf-af)# redistribute bgp 65500

ESR1(config-bgp-vrf-af)# exit

ESR1(config-bgp-vrf)# enable

ESR1(config-bgp-vrf)# exit

ESR1(config-bgp)# exit

ESR1(config)# do commit

ESR1(config)# do confirm

When passing routes from VRF to the VPNv4 table of only connected and/or static networks, you do

not need to specify the enable command.Enabling is required only if there are BGP peers in the VRF.

ESR1(config)# router bgp 65500

ESR1(config-bgp)# router-id 1.1.1.1

ESR1(config-bgp)# neighbor 3.3.3.3

ESR1(config-bgp-neighbor)# remote-as 65500

ESR1(config-bgp-neighbor)# update-source 1.1.1.1

ESR1(config-bgp-neighbor)# enable

ESR1(config-bgp-neighbor)# address-family vpnv4 unicast

ESR1(config-bgp-neighbor-af)# send-community extended

ESR1(config-bgp-neighbor-af)# enable

ESR1(config-bgp-neighbor-af)# exit

ESR1(config-bgp-neighbor)# exit

ESR1(config-bgp)# enable

EESR1(config-bgp)# vrf Customer1