EPSON Stylus COLOR 3000
EPSON Stylus Color 3000 Service Manual
-3
Table 5-3. LED Error Status and Solutions
Printer Status Power Pause
Paper
Out
Ink
Out
Media
Type
Solution
Power on On
Processing Data Blinks
Paper Out
On
After loading paper, press the
Pause button and then press
the Load/Eject button.
Paper Jam
Blinks
After removing paper, press the
Pause button and then press
the Load/Eject button.
Print ready On
During ink sequence
Blinks
No cartridge or ink
out
On *
Replace the ink cartridge.
Ink low
Blinks*
Have a new cartridge ready.
Fatal error Blinks Blinks Blinks Blinks
†
Blinks Turn the printer off and back on.
Release lever error
Blinks
Set the lever back to the
previous position and eject the
loaded paper. Then set the
lever to the appropriate position
for the selected type of paper.
Maintenance
requested
Blinks Blinks Blinks On
†
Blinks
Replace the waste ink drain
pads and reset the EEPROM.
(See pages 1-25 and 3-15.)
Reset,
Timer IC reset,
EEPROM Clear
All go on for 1 second.
∗: Corresponding Ink Out LED indicator goes on.
†: All Ink Out LED indicators go on.