CHAPTER 9
Video terminal VT190W
405.1200.037.2 - Rel.: 2.21 of 25/02/2008
9-16
The choice should be according to the speed you intend to use for the trans-
fer (Slow=9600bit/sec or Fast=38400bit/sec), press the corresponding func-
tion . The VT is now ready to receive (see Software Manual for the
transfer).
Information
relating to
driver
After the project has been transferred, the VT can make available informa-
tion relating to what has been loaded. The information regards:
• The name of the driver loaded
• The version of the driver loaded
• Network address of the VT
• Last error to have occurred
To acquire this information carry out the following operations:
• Be situated in any page of the project
• Press twice; you will see
• Press or ; you will see
If while displaying this page you press you will access the page for set-
ting the clock and the contrast
Boot sequence forced
F1= SLOW dn/up load
F2= FAST dn/up load
Shift
VT190W
Serial: xxxxxxxxxxxxx
Driver: xxxxxxxxxxxxx
Ver. : xxxxxxxxxxxxx
PgDn PgUp
Addr. : xxxxxxxxxxxxx
Error : xxxxxxxxxxxxx
Up/Down = next page
Enter = settings page
Enter
To Next Page
Loading...
