Test Results
572 FTBx-88000 Series
Summary - EtherSAM
Committed
Frame Loss Rate indicates the rate of frames that are lost. The
reported value is the maximum rate of Frame Loss from all burst
sequences and ramp steps excluding the CIR+EIR, EBS, and
Traffic Policing steps. Frame Loss is displayed as a percentage
value when the remote module does not support exponential
notation.
Max. Jitter indicates the maximum measured delay variation.
Max Latency indicates the maximum measured round-trip latency
(delay). For Dual Test Set the local to remote and remote to local
values are reported for One-Way Latency Measurement Mode
while a single round-trip value is reported for Round-Trip Latency
Measurement Mode (see Global Options on page 275).
Avg RX Rate, for Service Performance Test, indicates the
measured average utilization throughput.
Excess
Max RX Rate, for Service Configuration Test, indicates the
measured maximum utilization throughput.
VLAN Preservation indicates if any VLAN mismatch (including VLAN
level, VLAN ID, Priority, and Drop Eligible) occurred during any step of a
Ramp or Burst tests as follows:
Grey: Undefined
Green: No Mismatch detected
Red: Mismatch detected
To Next Page
Loading...
